冷再生机的操作规程

Operating procedures for cold regeneration machines

　　一、准备工作

1、 Preparation work

　　1.检查冷再生机的外观，确认设备是否完好，并检查相关配件。

1. Check the appearance of the cold regeneration system, confirm if the equipment is in good condition, and inspect the relevant accessories.

　　2.检查设备的工作区域和周边环境，保证安全和通风条件。

2. Check the working area and surrounding environment of the equipment to ensure safety and ventilation conditions.

　　3.检查冷再生机的电气系统是否正常，电源接口是否稳定可靠。

3. Check whether the electrical system of the cold regeneration is normal and whether the power interface is stable and reliable.

　　4.检查冷再生机的水路系统，调整水量和水压。

4. Check the water system for cold regeneration, adjust the water volume and pressure.

　　二、操作步骤

2、 Operation steps

　　1.开机操作

1. Power on operation

　　（1）按下开机按钮，启动冷再生机。

(1) Press the power button to start the cold regeneration machine.

　　（2）打开水泵，使水流经过冷再生机，循环流动。

(2) Turn on the water pump and allow the water flow to circulate through the cold regeneration machine.

　　（3）设定冷再生机的计时器和温度控制器，并验证其功能。

(3) Set the timer and temperature controller of the cold regeneration machine and verify their functionality.

　　2.冷却操作

2. Cooling operation

　　（1）将需要冷却的物品放入冷藏室中，注意不要堆积过高。

(1) Put the items that need to be cooled into the refrigeration room, being careful not to pile them up too high.

　　（2）调整温度，使设备开始工作，直到达到预设的温度。

(2) Adjust the temperature to start the device working until it reaches the preset temperature.

　　3.停机操作

3. Shutdown operation

　　（1）按下停机按钮，停止冷再生机的工作。

(1) Press the shutdown button to stop the operation of the cold regeneration machine.

　　（2）关闭水泵，中止水的循环流动。

(2) Turn off the water pump and stop the circulation of water in the middle.

　　（3）将冷藏室中的物品清理干净，关上门。

(3) Clean up the items in the refrigeration room and close the door.

　　三、注意事项

3、 Precautions

　　1.操作前必须检查设备正常，防止出现故障。

1. Before operation, it is necessary to check that the equipment is functioning properly to prevent malfunctions.

　　2.使用前应保证工作区域清洁干净，避免进入杂质和异物。

2. Before use, ensure that the work area is clean and avoid entering impurities and foreign objects.

　　3.操作时必须戴上手套和安全帽等个人防护装备。

3. Personal protective equipment such as gloves and safety helmets must be worn during operation.

　　4.操作期间不得随意触摸设备和工作区域。

4. During operation, do not touch the equipment and work area without permission.

　　5.设备必须经常保养和清洁，以延长使用寿命。

5. The equipment must be regularly maintained and cleaned to extend its service life.

　　6.操作结束后，及时关闭设备和清理工作区域。

6. After the operation is completed, promptly shut down the equipment and clean the work area.

本文来自：冷再生机租赁 更多的内容请点击：https://www.sddhfjx.com 我们将会为您提问的问题提供一个满意的服务，欢迎您的来电！

This article is from: Cold Recycling Machine Rental. For more information, please click on: https://www.sddhfjx.com We will provide satisfactory service for the questions you ask. Welcome to call us!