公司新闻
冷再生机机械的保养注意事项
来源：https://www.sddhfjx.com/ 日期：2023-06-28
一、清洗外表
1、 Cleaning the exterior
1、冷再生机租赁在施工过程中会有大量的灰尘落到再生机的表面，包括施工中沾污的油迹等污染物，影响外观事小，更为严重的是成为腐蚀的诱发因素。
1. During the construction process of the cold regeneration machine, a large amount of dust will fall onto the surface of the regeneration machine, including pollutants such as oil stains during construction, which have a small impact on the appearance and, more seriously, become an inducing factor for corrosion.
1.清洗工程机械的柴油机、底盘、工作装置的外表,除垢、除油保持再生机的外观整洁。
1. Clean the exterior of the diesel engine, chassis, and working equipment of the construction machinery, remove dirt and oil, and keep the appearance of the regeneration engine clean.
2.清洗时严禁用高压、高温的水枪来冲洗防水要求较高的部位（特别是电器部分），以免造成电器部分的损坏。
2. It is strictly prohibited to use high-pressure and high-temperature water guns to wash parts with high waterproof requirements (especially electrical parts) during cleaning, in order to avoid damage to the electrical parts.
清洗外表，是工程机械冬季保养要点之一。
Cleaning the exterior is one of the key points for winter maintenance of construction machinery.
二、保养转子及其罩壳和滑靴
2、 Maintain the rotor and its casing and shoes
1.检查转子是否有水泥结垢等，及时清理灰尘，对需要割除、焊接的刀具及时更换；
1. Check if there is cement scaling on the rotor, clean the dust in a timely manner, and replace the cutting tools that need to be cut or welded in a timely manner;
2.清理转子罩壳上的灰尘，并在施工结束收车时将转子罩壳垫起地面5-10公分，防止雨雪的浸蚀；
2. Clean the dust on the rotor casing and pad the rotor casing 5-10 cm above the ground at the end of construction to prevent erosion by rain and snow;
3.检查滑靴，对已经磨损的滑靴部分进行补焊，螺纹处应涂抹黄油防锈。
3. Check the sliding shoes, repair welding the worn parts of the sliding shoes, and apply butter to the threads for rust prevention.
三、减速机齿轮油的更换方式
3、 Replacement method of reducer Gear oil
准备事项：
Preparation:
1、场地:要求无尘硬化路面，面积应在200平方米左右，尽量是库房，但要有足够25吨的吊车的工作高度和半径。
1. Site: Dust free and hardened road surface is required, with an area of about 200 square meters. It should be a warehouse as much as possible, but there should be a sufficient working height and radius for a 25 ton crane.
2、设施：25吨吊车一台（20吨也可以）。
2. Facilities: One 25 ton crane (20 tons is also acceptable).
3、配件：进口美孚齿轮油9升、卫生纸10卷、塑料带20个、废油桶2个、紧固胶262/340一支、密封胶587一支、黄油一袋，细线绳20米、12*45的带母螺栓30套、4*30开口销10个。
3. Accessories: 9 liters of imported Mobil Gear oil, 10 rolls of toilet paper, 20 plastic belts, 2 waste oil drums, a piece of fastening glue 262/340, a piece of sealant 587, a bag of butter, 20 meters of string, 30 sets of 12 * 45 bolts with nuts, and 10 4 * 30 cotter pins.
4、工具：10、16、18、19、21、22、24、30套筒和扳手至少一套、快速扳手及长、短接杆各一、加力杆一根、30的轮胎扳手、10毫米的内六角扳手、55的活口扳手两把、小号活口扳手一把、小号的老虎钳一把、手钳一把、一字螺丝刀一把、大小锤头各一、撬棍两根，配备气动扳手和气泵，能提高工作效率。
4. Tools: at least one set of 10, 16, 18, 19, 21, 22, 24, 30 sockets and wrenches, one quick wrench, one long and short connecting rod, one booster rod, 30 tire wrench, 10 mm Hex key, two 55 open-end wrenches, one small open-end wrench, one small Lineman's pliers, one hand wrench, one slotted screwdriver, one large and small hammer head, two crowbars, and equipped with Impact wrench and air pump, which can improve working efficiency.
以上是关于冷再生机机械的保养注意事项，大家如有更多的想法和意见欢迎洽谈合作，本公司https://www.sddhfjx.com租赁冷再生机，铣刨机出租，摊铺机租赁，出租冷再生机等，常年对外出租各种大型机械！
The above are the maintenance precautions for the cold regeneration machine machinery. If you have more ideas and opinions, please feel free to negotiate cooperation. Our company https://www.sddhfjx.com Rental of cold regeneration machines, milling machines, paving machines, rental of cold regeneration vitality, and long-term rental of various large machinery to the public!
公司地址：济南市槐荫区经一路273号群盛华城2号楼1-404
公司名称：山东途畅路桥工程有限公司 
备案号：