行业资讯
撒布车液压油箱的使用与维护保养
来源:https://www.sddhfjx.com/ 日期:2023-05-15
撒布车液压油箱位于前仓内,配装于前仓仓壁上,主要起到降温散热的作用。下面水泥撒布车出租厂家为您讲解下相关事项:
The hydraulic oil tank of the spreader is located in the front compartment and is installed on the wall of the front compartment, mainly for cooling and heat dissipation. The manufacturer of cement spreader trucks will explain the relevant matters to you below:
平时使用撒布车液压油箱的时候我们要注意以下几点:
When using the hydraulic oil tank of the spreader, we should pay attention to the following points:
(1)、液压油的补加
(1) Hydraulic oil replenishment
液压系统所使用的液压油为46#高清洁抗压耐磨液压油,补加的时候要特别注意,一定要把加油口处的粉尘清理干净,并适量补加,不要超过观察孔处的红色点位,以免液压油加多了产生外溢。如有外溢,请不要用水清洗,可选择擦拭清理的方式处理。
The hydraulic oil used in the hydraulic system is 46 # high clean, pressure resistant, and wear-resistant hydraulic oil. Special attention should be paid when adding it. The dust at the oil filling port must be cleaned and an appropriate amount should be added, not exceeding the red dot at the observation hole, to avoid overflow caused by adding too much hydraulic oil. If there is any overflow, please do not use water to clean it. You can choose to wipe and clean it.
(2)、液压油箱的吹扫
(2) Purging of hydraulic oil tank
因工作环境特殊,粉尘量较大,液压油箱的散热片会沾附较多粉尘,粉尘的沾附会影响液压油油温的下降并增加散热风扇的运转时间。因此,油箱散热片需要定期吹扫,吹扫的时候气枪不要离散热片过近,以免碰伤散热片。
Due to the special working environment and high dust content, the cooling fins of the hydraulic oil tank may be contaminated with a large amount of dust, which can affect the decrease in hydraulic oil temperature and increase the operating time of the cooling fan. Therefore, the fuel tank heat sink needs to be regularly purged, and the air gun should not be too close to the heat sink during purging to avoid damaging it.
(3)、溢流管
(3) Overflow pipe
溢流管可能会因工作环境或其他原因产生溢流,正常使用的时候可能会有部分师傅为了维持前仓的清洁选择在溢流管下方配装一个瓶子,此时应特别注意,溢流管的下端不能没入到瓶内的液压油内,以免瓶内不清洁的液压油因压力等原因回吸到油箱内,污染液压系统的清洁度,甚至产生相关的车辆故障。
The overflow pipe may overflow due to working environment or other reasons. During normal use, some workers may choose to install a bottle under the overflow pipe to maintain the cleanliness of the front compartment. At this time, special attention should be paid to the bottom of the overflow pipe not to fall into the hydraulic oil inside the bottle, to prevent the unclean hydraulic oil inside the bottle from being sucked back into the oil tank due to pressure or other reasons, which may contaminate the cleanliness of the hydraulic system, Even related vehicle malfunctions may occur.
(4)、液压油箱相关连接管件
(4) Hydraulic oil tank related connecting pipe fittings
液压油箱相关连接管件需要定期检查,查看有无松动现象,如有松动,及时复紧,以免产生液压油渗漏。
The relevant connecting fittings of the hydraulic oil tank need to be regularly inspected to see if there is any looseness. If there is looseness, it should be re tightened in a timely manner to avoid hydraulic oil leakage.
应特别注意,液压油箱散热风扇虽然会自动开启降温,但在使用过程中也会存在一定量的粉尘堆积,粉尘的堆积会影响散热片的散热效果,也会影响风扇的开启与关闭时间,影响着散热风扇的使用寿命。
Special attention should be paid to the fact that although the hydraulic oil tank cooling fan automatically starts to cool down, there may also be a certain amount of dust accumulation during use. The accumulation of dust can affect the heat dissipation effect of the cooling fins, as well as the opening and closing time of the fan, affecting the service life of the cooling fan.
所以,液压油箱散热器的散热片要定期用压缩气体进行吹扫,吹扫时气枪不要碰到散热器散热片,各角落均要吹扫到。只有这样,才能达到理想的散温效果及延长设备的使用寿命。更多相关事项就来我们网站https://www.sddhfjx.com咨询!
So, the heat dissipation fins of the hydraulic oil tank radiator should be regularly purged with compressed gas. When purging, the air gun should not touch the heat dissipation fins of the radiator, and all corners should be purged. Only in this way can the ideal temperature dissipation effect be achieved and the service life of the equipment be extended. For more related matters, come to our website https://www.sddhfjx.com consulting service