行业资讯
物料撒布施工需要注意的事项
来源:https://www.sddhfjx.com/ 日期:2022-05-26
物料撒布施工需要注意的事项
Matters needing attention in material distribution construction
因设计要求不同,各施工撒布物料也不尽相同。目前,施工物料多为水泥、白灰,但也有物料为土凝岩、粉煤灰等。
Due to different design requirements, the construction materials are not the same. At present, the construction materials are mostly cement and lime, but there are also some materials such as concrete rock and fly ash.
目前,市面上的水泥多稳定,但也存在掺杂粉煤灰量过大而造成撒布扬尘和打料扬尘大的现象。
At present, the cement on the market is mostly stable, but there is also a phenomenon that the amount of doped fly ash is too large, resulting in large dust from spreading and striking.
白灰一般要求为球磨白灰,但受多方面制约,目前市面上的白灰多掺杂石粉、石硝等,造成白灰干湿度、颗粒度等不好掌控,给白灰施工造成了非常大的影响。针对于不同的物料,在施工过程中大家要注意以下几点:
Generally, the white ash is required to be ball milled white ash, but it is restricted by many aspects. At present, the white ash on the market is mostly mixed with stone powder and stone nitrate, which makes it difficult to control the dry humidity and particle size of the white ash, and has a great impact on the white ash construction. For different materials, we should pay attention to the following points during construction:
(1)物料不要长时间在车厢内存放,及时排放干净。
(1) Materials shall not be stored in the carriage for a long time and shall be discharged in time.
(2)不要颠簸运输。
(2) Do not transport bumpily.
(3)根据物料适当调整车厢内部人字架缝隙及均整器角度,均整器振动器常开。
(3) Adjust the A-frame gap and equalizer angle inside the carriage properly according to the materials, and the equalizer vibrator is normally open.
(4)如白灰湿度大在车厢内搭桥,可根据实际搭桥位置调整物料减重锥副板缝隙,调整后随时注意液压压力变化情况。
(4) If the lime is wet enough to bridge in the carriage, the gap of the material weight reduction cone sub plate can be adjusted according to the actual bridging position. After adjustment, pay attention to the change of hydraulic pressure at any time.
(5)如白灰含一定颗粒或粘度、湿度偏大,绞龙、计量器启动液压压力偏高,可选择绞龙、计量器间隔性启动,以保证传输动力及疏通绞龙、计量器。(压力过高会增加机械磨损程度,建议调整物料配比)
(5) If the white ash contains certain particles or the viscosity and humidity are too high, and the hydraulic pressure for starting the auger and the gauge is too high, the auger and the gauge can be started at intervals to ensure the transmission of power and dredge the auger and the gauge. (too high pressure will increase the degree of mechanical wear, so it is recommended to adjust the material ratio)
(6)适当调整绞龙、计量器标定参数,绞龙标定适当上调,计量器标定适当下调,车速适当提高(如有不明白之处,请及时致电全国服务热线:400-000-8839,我们会安排专业的技术人员给您技术指导)。
(6) Properly adjust the calibration parameters of the auger and the gauge, appropriately increase the calibration of the auger, appropriately reduce the calibration of the gauge, and appropriately increase the vehicle speed (if you do not understand, please call the national service hotline at 400-000-8839 in time, and we will arrange professional technicians to give you technical guidance).
(7)陷车路面随时注意后方物料撒布情况,路面的不平整、下陷随时有可能会影响撒布效果。
(7) Pay attention to the distribution of materials behind the sunken road at any time. The uneven and sunken road may affect the distribution effect at any time.
(8)白灰如在布料器、计量器软连接内产生堆积,应及时清理。
(8) If the lime accumulates in the soft connection of the distributor and the meter, it shall be cleaned in time.
本文的精彩内容由水泥撒布车租赁提供知识提供,本网站还有很多的精彩内容,更多的内容您可以点击进入https://www.sddhfjx.com我们有专门的客服为您解答问题
The wonderful contents of this article are provided by the knowledge provided by the cement spreader rental. There are many wonderful contents on this website. You can click to enter more contents https://www.sddhfjx.com We have special customer service to answer your questions