公司新闻
沥青水泥撒布车常见的故障及如何处理!
来源:https://www.sddhfjx.com/ 日期:2021-05-10
沥青撒布车经过一定时期的施工使用,由于操作程序不到位或操作错误,或施工后未及时对车辆进行清理和保养,使车辆在下一次施工时会出现一些故障。为了让广大用户熟练、正确地掌握沥青撒布车使用方法,本公司就沥青撒布车常见的故障原因及处理方法介绍给大家。
After a certain period of construction and use, due to the operation procedure is not in place or wrong operation, or the vehicle is not cleaned and maintained in time after construction, the vehicle will have some faults in the next construction. In order to let the majority of users skillfully and correctly grasp the use of asphalt spreader, the company introduces the common fault causes and treatment methods of asphalt spreader.
沥青撒布车常见故障原因及故障处理方法
Common fault causes and troubleshooting of asphalt spreader
故障一、无沥青喷出:
Fault 1: no asphalt spray
原因分析:1、沥青泵没工作;2、阀门开闭位置不对;3、泵或管路堵塞。
Cause analysis: 1. The asphalt pump didn't work; 2. The opening and closing position of the valve is not correct; 3. The pump or pipeline is blocked.
故障排除方法:1、检查液压系统是否工作正常;2、调整阀门开闭位置;3、烘烤或疏通。
Troubleshooting: 1. Check whether the hydraulic system works normally; 2. Adjust the opening and closing position of the valve; 3. Bake or dredge.
故障二、喷洒压力不足:
Second, insufficient spraying pressure
原因分析:1、沥青温度太低;2、回油阀3没关闭;3、沥青泵磨损;4、比例阀损坏;5、液压系统压力不足;6、滤清器堵塞。
Cause analysis: 1. The temperature of asphalt is too low; 2. Return valve 3 is not closed; 3. The asphalt pump is worn; 4. The proportional valve is damaged; 5. The pressure of hydraulic system is insufficient; 6. The filter is blocked.
故障排除方法:1、加热沥青到规定温度;2、关闭回油阀;3、更换沥青泵;4、更换比例阀;5、检查液压系统;6、拆下清洗。
Troubleshooting: 1. Heat asphalt to the specified temperature; 2. Close the oil return valve; 3. Replace the asphalt pump; 4. Replace the proportional valve; 5. Check the hydraulic system; 6. Remove the washer.
故障三、沥青喷洒不均:
Fault 3: uneven asphalt spraying:
原因分析:1、喷洒压力不足;2、管道或喷嘴有杂质堵塞;3、沥青温度太低。
Cause analysis: 1. Insufficient spraying pressure; 2. The pipe or nozzle is blocked by impurities; 3. The temperature of asphalt is too low.
故障排除方法:1、按上述检查调整;2、清洗杂质。
Troubleshooting: 1. Adjust according to the above inspection; 2. Clean impurities.
故障四、清洗装置气压过低:
Fault 4: the air pressure of the cleaning device is too low
原因分析:1、空气压缩机皮带太松;2、空气压缩机阀座松动、阀片发卡或损坏;3、贮气筒或接头漏气。
Cause analysis: 1. The belt of air compressor is too loose; 2. The valve seat of air compressor is loose, the valve plate is jammed or damaged; 3. The air reservoir or joint leaks.
故障排除方法:1、调整皮带张紧度;2、调整或更换;3、拧紧接头或修理。
Troubleshooting: 1. Adjust the belt tension; 2. Adjustment or replacement; 3. Tighten the connector or repair it.
故障五、沥青泵渗沥青:
Fault 5: asphalt pump seeps asphalt
原因分析:轴颈处填料磨损。
Cause analysis: the packing at the journal is worn.
故障排除方法:适当拧进螺母或加少量盘根。
Troubleshooting: screw in the nut properly or add a small amount of packing.
本文由水泥撒布车租赁整理提供,感谢您的阅读,希望以上内容对您有所帮助,如您想了解更多精彩内容请点击我们的官网:https://www.sddhfjx.com。
This article is provided by the cement spreader. Thank you for your reading. I hope the above content can help you. If you want to know more wonderful content, please click our official website: https://www.sddhfjx.com .