欢迎访问山东途畅路桥工程有限公司网站!

冷再生机租赁,水泥撒布车出租

施工租赁热线

18264104888

您现在所在的位置 :首页 - 新闻中心 > 公司新闻
公司新闻

水泥撒布车在施工完后该怎么办?
来源:https://www.sddhfjx.com/ 日期:2021-04-25
水泥撒布车作为一种路面施工机械,我们在使用它的时候一定要注意操作规范和保养,这样才能让车辆减少故障率,使用年限更久,而且在使用该车的时候,一定要注意清洗。就算有导热油系统,及时清洗也是为车辆保养的一种好习惯。
As a kind of road construction machinery, we must pay attention to the operation specification and maintenance when using the cement spreader, so as to reduce the failure rate and prolong the service life of the vehicle, and pay attention to the cleaning when using the vehicle. Even if there is a heat transfer oil system, timely cleaning is also a good habit for vehicle maintenance.
那么我们在使用车辆施工完成后,应该怎么办,下面小编给大家介绍一下用车小知识。
So what should we do after the completion of the construction of using vehicles? Let's introduce the knowledge of using vehicles.
若施工作业完成后,沥青罐内仍有少量剩余沥青,可利用排放口予以排放。
If there is still a small amount of residual asphalt in the asphalt tank after the construction is completed, it can be discharged through the discharge port.
若沥青剩余较多,则可使用强排功能:在强排口连接软管,打开阀门①及强排阀⑦,然后启动沥青泵。
If there is a lot of asphalt left, the forced discharge function can be used: connect the hose at the forced discharge outlet, open valve ① and forced discharge valve ⑦, and then start the asphalt pump.
待沥青罐内剩余沥青排尽后,对沥青泵及管路进行清洗。
After the remaining asphalt in the asphalt tank is discharged, the asphalt pump and pipeline shall be cleaned.
关闭所有阀门,打开高压空气冲洗系统球阀,对后喷管进行清洗,使残余沥青经喷嘴排出。
Close all valves, open the ball valve of high pressure air flushing system, clean the rear nozzle, and discharge the residual asphalt through the nozzle.
若使用过手喷枪,则关闭手喷枪控制球阀,打开高压空气冲洗系统球阀,对手喷枪进行清洗。
If the hand spray gun is used, close the control ball valve of the hand spray gun, open the ball valve of the high pressure air flushing system, and clean the hand spray gun.
在对沥青泵和管路进行清洗后,必须关闭冲洗系统各球阀。
After cleaning the asphalt pump and pipeline, all ball valves of flushing system must be closed.
             水泥撒布车租赁
撒布车在施工作业完成、清理工作实施后,应进行复位。
The spreader should be reset after the completion of construction and cleaning.
关闭所有阀门;
Close all valves;
将后排管折叠,插入插销固定;
Fold the rear pipe and insert the bolt to fix it;
在后控制台操作提升气缸将后排管提升至上限位置,并利用挂钩将其固定。
Operate the lifting cylinder in the rear console to lift the rear pipe to the upper limit position, and fix it with the hook.
对沥青软管进行检查、复位、防止扭曲;
Check, reset and prevent twist of asphalt hose;
检查冲洗系统各球阀,并予以关闭;
Check and close all ball valves of flushing system;
检查减速器是否脱档,拔叉复位。
Check whether the reducer is out of gear, and pull the fork to reset.
撒布车在使用过程中,应按时进行技术保养,以保证机械正常运行,延长机械的使用寿命。撒布车除底盘部分按《汽车使用说明书》严格进行各级技术保养外,还应做好下列工作:
In the process of using the spreader, technical maintenance should be carried out on time to ensure the normal operation of the machine and extend the service life of the machine. In addition to the strict technical maintenance of the chassis according to the vehicle operation manual, the spreader should also do the following work:
检查取力器、传动系统工作情况和各螺栓的紧固情况。
Check the working condition of power take-off and transmission system and the tightening condition of bolts.
检查液压管道各接头是否漏油。
Check the hydraulic pipe joints for oil leakage.
检查液压油箱油面是否正常。不够应当及时补充。
Check whether the oil level of hydraulic oil tank is normal. If it is not enough, it should be supplemented in time.
检查沥青泵的工作是否正常。
Check whether the asphalt pump works normally.
检查各阀门和管路连接处是否正常,如有损坏,应更换和维修。
Check whether the connection of valves and pipelines is normal. If there is any damage, it should be replaced and repaired.
检查进油滤清器是否被沥青和杂质堵塞。
Check whether the oil inlet filter is blocked by asphalt and impurities.
使用一段时间后,应清除罐内的杂质。
After using for a period of time, the impurities in the tank should be removed.
以上是给大家分享的一些用车小知识,希望对大家有所帮助。
The above is to share with you some car knowledge, I hope to help you.
  • 上一条:冷再生机的运行要如何把控?
  • 下一条:厂拌冷再生反射裂缝及施工现场状况!
  • 相关产品: