欢迎访问山东途畅路桥工程有限公司网站!

冷再生机租赁,水泥撒布车出租

施工租赁热线

18264104888

您现在所在的位置 :首页 - 新闻中心 > 公司新闻
公司新闻

智能撒布车的施工预防措施和维护要求!
来源:https://www.sddhfjx.com/ 日期:2021-02-26
  智能水泥撒布车是公路维护和修理中必不可少的工具,随着公路建设的不断发展,对智能撒布车的需求也在增加。
  Intelligent cement spreader is an indispensable tool in highway maintenance and repair. With the continuous development of highway construction, the demand for intelligent spreader is also increasing.
  使用智能喷头时,应注意以下几点:
  When using intelligent sprinkler head, the following points should be paid attention to:
  1.在操作前,应检查轿厢的各个部分,管道系统的阀门,喷嘴和其他工作装置,它们可以正常使用而不会出现故障。
  1. Before operation, check all parts of the car, valves, nozzles and other working devices of the pipeline system, which can be used normally without failure.
  2.在检查同步密封小车无故障后,将小车驶入加油管下方,首先将所有阀门置于关闭位置,打开油箱顶部的小油箱盖,将加油管放入,然后启动加注沥青并加油完成后,关闭小加油口盖,填充的沥青要满足温度要求,并且不能填充得太满。
  2. After checking that the synchronous sealing car is free of fault, drive the car under the oil filling pipe. First, put all the valves in the closed position, open the small oil tank cover on the top of the oil tank, put the oil filling pipe in, and then start filling asphalt and fill the oil. After the completion of filling, close the small filler cap. The filled asphalt should meet the temperature requirements and not be filled too full.
  3.在智能撒布车中装满沥青和碎石后,它会缓慢启动,并保持中速行驶到施工现场。
  3. After the intelligent spreader is filled with asphalt and gravel, it will start slowly and drive to the construction site at medium speed.
                   水泥撒布车租赁
  4.运至施工现场后,如果同步密封车罐体中的沥青温度不能满足喷涂要求,则必须加热沥青,在沥青加热过程中,可以打开沥青泵以实现均匀的温度上升,我公司生产的同步砾石密封取力器可以在行驶过程中关闭并加热。
  4. After being transported to the construction site, if the asphalt temperature in the tank of the synchronous sealing vehicle can not meet the spraying requirements, the asphalt must be heated. During the asphalt heating process, the asphalt pump can be turned on to realize uniform temperature rise. The synchronous gravel sealing power take-off produced by our company can be closed and heated during driving.
  5.罐中的沥青达到喷涂要求后,将同步密封车驶至后喷嘴,从操作起点开始在约1.5-2m处停止,根据施工要求,可以选择在前台控制自动喷涂,在后台控制手动喷涂,在运行过程中,禁止站在中间平台上,必须保持匀速行驶,禁止踩油门。
  5. After the asphalt in the tank meets the spraying requirements, drive the synchronous sealing vehicle to the rear nozzle and stop at about 1.5-2m from the starting point of operation. According to the construction requirements, automatic spraying can be controlled at the front desk, and manual spraying can be controlled in the background. During the operation, it is forbidden to stand on the intermediate platform, and driving at a constant speed must be maintained, and it is forbidden to step on the accelerator.
  6.当操作完成或施工现场改变一半时,必须清洗过滤器,沥青泵,管道和喷嘴。
  6. When the operation is completed or half of the construction site is changed, the filter, asphalt pump, pipeline and nozzle must be cleaned.
  7.每天使用智能喷头后,您必须清洁同步车,以使智能喷头能够长期为我们工作。
  7. After using the intelligent sprinkler every day, you must clean the synchronous car, so that the intelligent sprinkler can work for us for a long time.
  以上是关于对智能撒布车的施工预防措施和维护要求的介绍,相信大家都有所了解了,如想了解更多内容欢迎点击水泥撒布车租赁网站。
  The above is about the construction of intelligent spreader preventive measures and maintenance requirements, I believe you all know, if you want to know more, welcome to click the cement spreader rental website.
  • 上一条:使用冷再生机路面平整工作是如何进行的?
  • 下一条:简述泡沫沥青冷再生技术的质量检测程序!
  • 相关产品: